November 27 - Today is the presentation milestone. Here is a link to my powerpoint.
November 20 - Today is the enclosure milestone. Today I created a diagram for a case that I would like to be made to enclose my PCB.In terms of the project schedule, I am a little behind scheudle as I need my case to be created. In terms of my budget, there has been no changes lately.
November 13 - Today is the power up milestone. I tried to create code that would allow me to read my sensor’s values and display them on the screen but I could not produce this code. In terms of the project schedule I am behind as I was no able to provide code that would display my readings and I will work on getting code to work throughout the week so that I could catch up and be on schedule. In terms of my budget, there has been no changes lately.
November 6 - Today was the PCB Soldered milestone. With reference to my Project Schedule, I am a bit behind as I have not finished soldering my PCB. In terms of my Budget, other than the wires i mentioned last week, everything is on plan with the budget.I will complete my soldering on Wednesday or Thursday and check to see if everything is okay and I will make sure that I am ready for the hardware demonstration.
October 30 - Today I used Fritzing to create a PCB and a breadboard diagram for my sensor.
As for the budget, I had to purchase wires that costed 11 dollars.
October 23 - Today I created the wiring for my Raspberry Pi and Wii Nunchuk connection. After I finished wiring the connection, I went into the Pi and checked the i2c device and made sure that the number that shows up is the correct number.
October 2 - Proof of Purchase Completed
September 25 - Budget Completed
September 18 - Gantt Schedule Chart and Proposal Completed
